Solar Street Light Manufacturer: Five Parts and the Number That Sizes Them
A solar street light is not one product. It is a panel, a battery, a controller, a lamp and a pole, and each of the five can fail on its own. Most quotes describe the lamp and leave the other four to chance. What the order has to fix in writing matters more here than in most categories.
The Short Answer
Ask how many nights the lamp runs without sun. That single number sizes the battery, and the battery is the most expensive part of the system.
Ask for the output in lumens at the fixture, not the wattage on the label. A stated wattage describes a component and not a result.
Ask where the controller sits and what its ingress rating is. A controller inside the head and a controller in the pole are two different service lives.
Then ask who supplies the pole. It is quoted last, it ships separately, and it is the item that holds up an install.
Five Parts, Five Failure Modes
The system is easier to buy once you see it as five parts. Each one fails in its own way, and each one is quoted by a different supplier.
The panel collects. It fails by losing output as it ages or by arriving with a crack that shows up after the first frost.
The battery stores. It fails by losing capacity, and capacity loss is invisible until the first week of grey weather.
The controller manages. It fails by charging badly or by letting the battery discharge too deep, and both shorten the life of the part next to it.
The lamp emits. It fails by losing output or by letting water in, and water in an LED head is a slow failure, not a sudden one.
The pole carries. It fails by bending, and that is a wind question, not an electrical one.
| Part | What it decides | How it fails |
|---|---|---|
| Panel | How fast the battery refills | Output drops with age, or cracks in frost |
| Battery | How many grey days the lamp survives | Capacity falls quietly |
| Controller | Whether the battery is charged and protected well | Bad charging, or deep discharge |
| Lamp | The light on the road | Output drop, or water in the head |
| Pole | Whether it stands in wind | Bending at the base |
The Four Numbers You Have to Supply
No factory can size a system without four facts about the site. A quote produced without them is a guess with a logo on it.
The first is the road. Its width and the light level the road class requires decide the lamp and the mounting height.
The second is the pole spacing. Wider spacing means taller poles and more output per head, and it changes the cost per kilometre, not the cost per lamp.
The third is the sun. Average hours of usable sun in the worst month is the number that matters, not the annual average.
The fourth is the nights without sun the install must survive. That is a decision, not a measurement, and it belongs to the buyer.
Send those four in one message and the sizing becomes a calculation. Leave them out and the reply will be a catalogue.
Autonomy Is the Number That Sizes Everything
Autonomy is the count of days a lamp keeps working with no useful sun. It is the first number to agree, because everything else is calculated from it.
A lamp sold for three grey days needs a battery three times the daily draw, plus a margin for ageing. A lamp sold for one grey day is a smaller battery and a cheaper system.
That is why two quotes for the same road can differ by a third. One is built for three days and the other is built for one, and neither sheet says so unless you ask.
Ask the question in the form the factory can answer. How many watt hours does the lamp draw in a night, and how many watt hours does the battery hold after two years.
The second half of that question is the one buyers forget. A battery is sized on its capacity at the end of its life, not on the day it is made. The sheet the sizing sits on should say so.
Battery Chemistry Decides Year Five
Two lamps can carry the same capacity and behave differently in year five. The chemistry inside the pack decides how many cycles it survives.
A lithium iron phosphate pack is heavier and holds its capacity over more cycles. It also behaves better in heat, which matters for a box mounted under a panel in the sun.
A ternary lithium pack is lighter and cheaper per unit of capacity, and it is less forgiving at high temperature and over deep discharge.
Lead acid is still sold in low-cost systems. It is heavy, it ages faster, and at the end of its life it becomes a disposal problem in the market you shipped it to.
Ask which chemistry, and ask where the pack is mounted. A pack in the head runs hot. A pack buried at the base of the pole runs cooler and lasts longer, and it is harder to steal.
Then ask what the warranty replaces. A pack that is covered in year one and not in year three is a two-year product sold as a five-year one.
Watts Are Not Lumens
A datasheet that leads with watts has told you about a component. The road needs lumens, and the gap between the two is where a cheap lamp is cheap.
Ask for output at the fixture, after the lens and the diffuser. Ask for the figure at the end of life, not the first hour, and ask what proportion is lost per year.
Ask for the light distribution too. A lamp with a narrow beam puts a bright patch under the pole. The space between poles stays dark, and that is the part a driver notices.
None of that is on a catalogue page. All of it comes out in one exchange with an engineer. That exchange is the difference between a lamp that lights a road and one that lights a circle.
Water, Dust and Where the Controller Sits
Ingress ratings describe how well a housing keeps dust and water out. Two ratings that look similar can still behave differently in service.
The first digit covers dust and the second covers water. A housing rated for strong jets is not by itself rated for temporary flooding. A lamp on a pole rarely meets either in the way the test intends.
Ask where the controller is mounted. Inside the head it shares the heat of the LED and the water that gets past the gasket. In the pole it is cooler and better protected, and it needs a longer cable.
Ask for the rating of each housing separately. A lamp rated well and a controller rated badly is a system rated badly, and the failure will be reported as a lamp failure. What a visit can check on a lamp is mostly the seal and the wiring.
Pole, Wind and the Part Nobody Quotes
The pole is quoted last and shipped separately. It is the item that turns a delivered lamp into a stalled project.
The wall thickness is set by the wind load at the site, not by the height of the pole. A windy coastal site and a sheltered inland site can need different poles for the same lamp.
Ask whether the pole is included, and if not, who supplies it. A pole from a second supplier is a second lead time and a second inspection.
Ask how the lamp attaches. A bracket designed for one pole diameter will not fit another, and the mismatch shows up on site, not in the quote.
Shipping is part of this decision. Poles are long, and length changes the freight calculation more than weight does. How a forwarder prices length is worth reading before the order.
What the Installer Needs
A lamp that arrives without the information an installer needs becomes a delay on site. That information costs nothing to send.
Ask for the tilt angle the panel should be set at for the latitude of the site. Ask for the torque figures for the bracket bolts too.
Ask for a wiring diagram that shows the controller, the battery and the lamp as they will be connected, with the cable sizes named.
Ask whether the lamp is set up by a switch sequence or by a remote. A crew that does not know will call the supplier from up the pole.
Then ask what happens if one head fails on a road of fifty. A replaceable head and a matched connector turn a fault into a swap, and a sealed unit turns it into a return.
Certification for the Destination
The right paperwork depends on where the lamp is installed. A quote that offers one generic certificate is answering a different question.
In the United States, projects that take a utility rebate often require the fixture to be listed on a qualified products list. That listing belongs to the model, not to the factory, and it is checked by the buyer before the order.
The DesignLights Consortium is where those lists are published, and the qualification requirements behind them are set out at the consortium’s solid state lighting pages.
Ask the factory for the listing reference for the exact model you are buying. A listing for a similar model with a different driver is not the same listing.
Other markets have their own schemes, and the safe question is always the same. What does the installer need to see, and can you show that document for this model.
What the Minimum Really Is
The minimum in this category is usually set by the container, not by the factory. A lamp without a pole is mostly air.
Heads pack densely. Poles do not. A mixed order takes the shape of the longest item. That is why a pole order fills a container long before it fills it by weight.
Ask for the minimum per model and per finish, then ask how many fit in one container with the poles included. The second answer is the one that changes the plan.
A first order is often heads only, with poles bought locally at the destination. That is a real option and worth costing, because a local pole avoids the freight and the length problem together.
What the Warranty Actually Covers
A five-year warranty on a solar street light covers four parts with four different failure rates. It is worth reading line by line.
Ask what is covered and for how long, part by part. A pack covered for two years inside a five-year document is a two-year pack.
Ask who ships a replacement. A board sent from the factory arrives in weeks. A board held locally arrives in days, and the price difference is usually visible in the quote.
Ask what voids it. Water in a housing opened on site is one. A battery charged by another controller is another. An install that ignored the tilt angle is a third.
Then ask for the clause in the order, not the brochure. A warranty is only as good as the sentence that names the part and the period.
Reading a Solar Light Quote
A solar street light quote hides its variables in five lines, and only one of them is the lamp.
| Line | What to confirm | What it protects |
|---|---|---|
| Panel | Type and rated output | A panel that cannot refill the battery in winter |
| Battery | Chemistry, capacity and mounting point | Year five capacity, and theft |
| Controller | Placement and its own ingress rating | A failure reported as a lamp fault |
| Lamp | Lumens at the fixture, at end of life | Paying for watts you cannot see |
| Pole and bracket | Included or not, and the wall thickness | A stalled install |
Ask for those five lines separately, with the autonomy figure written first. A single price for a solar light is a number with four unknown parts.
Questions Buyers Ask About Solar Street Lights
How do I know what battery size I need?
Start from the autonomy you need, in nights without sun, and from the lamp’s nightly draw. The battery is sized on its capacity at end of life, not on day one.
Is a higher wattage lamp brighter?
Not reliably. Ask for lumens at the fixture and for the figure at end of life, because a stated wattage describes a part, not the light on the road.
Which battery chemistry should I choose?
Lithium iron phosphate lasts more cycles and behaves better in heat. Ternary lithium is lighter and cheaper, and less forgiving at high temperature.
Does the quote include the pole?
Often not. Ask directly, and ask who supplies it, because a pole from another supplier adds a lead time and a second inspection.
What certification do I need for the United States?
Projects taking a rebate usually require the model to appear on a qualified products list. Ask the factory for the listing reference for the exact model.
Why does the controller matter so much?
It decides how the battery is charged and how deep it discharges. A poor controller shortens the life of the most expensive part in the system.
The Bottom Line
Agree the autonomy first, then size the battery, then ask for lumens at the fixture, then find out who is supplying the pole.
Those four answers decide the price and the warranty. The rest of the datasheet is decoration.
Send the Site Details
Send us the road, the pole spacing and the number of nights without sun you need to cover. We will ask the factory for the battery sizing behind the quote, the lumens at the fixture, and who supplies the pole and bracket.
Send the Site
Questions & Comments
We read every one and reply within 24 hoursBeen quoted a wattage and nothing about the battery? Tell us the road and the nights without sun. We will say what the sizing should have been based on.