What Is A Cuban Link Chain: Hollow, Solid, And The Gram
A Cuban link chain is a flattened, tightly fitted chain of curb links.
Each link is pressed flat and set at an angle to the one before it. The links sit close enough that the chain lies flat and shows a run of metal rather than a row of holes.
Two numbers describe it: width in millimetres, and weight in grams. Everything else a buyer argues about follows from those two.
This article gives the gram arithmetic, the hollow trade, and the words that may and may not go on the stamp.
The Short Answer
The link is a flattened oval, twisted so that each one catches the light on a face rather than an edge. A tight Cuban has almost no gap between neighbours.
That tightness is the whole trick. Loose links rattle and turn; tight links lock into a flat band that drapes over the collarbone instead of standing off it.
The width runs from about 2 mm on a fine chain to 14 mm and beyond on the heavy men’s sizes. Anything past roughly 10 mm is a statement piece and weighs accordingly.
The same width can be built three ways: solid, semi-solid, or hollow. Those three words describe how much metal is inside the link, and they change the gram, the price and the law.
Width And The Gram
Width is a single measurement at the widest part of a link. It is easy to state and easy to check with a caliper.
Grams are harder, because the weight of a chain is the weight of metal, and metal is volume times density. Two chains of the same width and length can differ by half.
So the calculation runs in three steps. Measure the metal, not the outline: the cross-section of the bar the link is made from, and the total length of bar in the chain.
Here is a worked example. A piece of bar 20 mm long and 4 mm square has a volume of 0.32 cubic centimetres.
At 15.5 grams per cubic centimetre, which is a fair figure for a yellow 18 karat alloy, that piece weighs about 5.0 grams. A whole chain is many such pieces joined.
Change the alloy and the number moves. Gold is dense, silver is lighter, and a 14 karat alloy sits below an 18 karat one because it carries less gold. That is why a gram figure without a stated alloy is not a specification.
The useful discipline is to ask for grams per piece with a tolerance, and grams per unit length. A chain is a long thin object, and a small error in width turns into a large error in weight.
Hollow, Semi-Solid, Solid
Hollow does not mean empty. It means the link is a tube instead of a bar, so the metal forms a wall around an air space.
The arithmetic is unforgiving. Take the same 4 mm cross-section and make it a tube with a 0.5 mm wall. The wall carries 44 percent of the metal of a solid bar.
That is a third of the weight removed from the parcel, the freight and the metal cost. It is also a thinner skin to resist a knock.
Semi-solid sits between the two. The link is formed with a thicker wall. Some builds are solid at the stress points and hollow along the run, which keeps the look without the full gram count.
| Build | Metal in the link | Weight | What fails first |
|---|---|---|---|
| Solid | Full bar | 100 percent | Stretch at the clasp |
| Semi-solid | Thick wall | 60 to 80 percent | Dent at a link face |
| Hollow | Thin tube | Under half | Dent, then a split seam |
A hollow chain is not a bad product. It is a different product, sold to a buyer who wants a wide look at a lower gram. It fails in a specific way: a knock flattens the tube, and the dent never comes out.
What a hollow chain cannot be is called solid. That is not a matter of taste, and it is the next section.
What The Stamp May Say
The United States rules on gold marking sit in the code text. Section 23.3 deals with gold content, and it addresses hollow pieces by name.
A hollow item may be marked 14 Karat Gold only if the hollow centre is disclosed right beside the word Gold. The rule gives the examples “14 Karat Gold-Hollow Center” and “14 K. Gold Tubing”.
The same paragraph says such a product “should not be marked or described as solid”. Its own example: a 14 karat hollow piece must not be called “14 Kt. Solid Gold” or “Solid 14 Kt. Gold”.
That is the sentence to put in front of a supplier who offers a wide hollow chain and a solid stamp. A stamp is a statement about metal, and a wrong one is a misrepresentation rather than a shortcut.
There is a second number in the same part, and it is the one to use at goods-in. Under the National Stamping Act the tolerance is three parts per thousand without solder. A piece that contains solder gets seven parts per thousand.
Seven parts per thousand is 0.7 percent. A 14 karat chain is 583 parts per thousand of gold, so 580 is inside the tolerance and 576 is not. An assay is cheap next to a return.
Karat Is A Fraction, Not A Colour
Karat is the share of gold in the alloy, out of twenty-four parts. It says nothing about how yellow the metal looks, because the other metals decide that.
So 18 karat is 75 percent gold, 14 karat is 58.3 percent, and 10 karat is 41.7 percent. A 9 karat alloy, common in the United Kingdom, is 37.5 percent.
The same twenty-four part scale runs on the stamp. A piece marked 14K and a piece marked 585 are claiming the same fineness in two languages, and both are used in the trade.
Colour comes from the rest. White alloys lean on palladium or nickel, rose alloys on copper, and yellow returns to silver and copper in different proportions. Two 14 karat chains can sit at different densities.
That is why the gram figure and the karat figure belong in the same sentence. A 20 inch chain at 14 karat and 30 grams is a specification; either half alone is a description.
Plating, Steel, And The Nickel Rule
Most wide Cuban chains sold at volume are not gold at all. They are brass or 316L stainless steel, plated, and sold at a price the gold gram will never reach.
Plating is where the claims get loose, and the same part of the rule book sets the floors. A gold electroplating needs a minimum thickness equivalent to 0.175 microns of fine gold before the word plate may be used.
At 2.5 microns the claim may become heavy gold electroplate. Between those two figures sits almost every plated chain on the market, and the difference is measurable on an X-ray gauge in seconds.
Mechanical plating has its own thresholds, and they are weight ratios rather than microns. Rolled gold plate needs at least one fortieth of the metal weight; gold filled needs one twentieth.
| Marking | Floor | Measured as | Common failure |
|---|---|---|---|
| Gold plated | 0.175 micron | Thickness, fine gold | Plated only on the visible face |
| Heavy gold plated | 2.5 microns | Thickness, fine gold | Thick on the link, thin at the joint |
| Rolled gold plate | 1/40 of metal weight | Weight ratio | Ratio quoted for the sheet, not the chain |
| Gold filled | 1/20 of metal weight | Weight ratio | Same |
Steel brings a different rule, and it is about release rather than content. Parts in direct and prolonged contact with skin must release no more than 0.5 micrograms of nickel per square centimetre per week.
Piercing parts are held to 0.2. The test method is EN 1811. The requirement sits in REACH Annex XVII entry 27, so a European buyer will ask for a report rather than a certificate of alloy.
A 316L chain usually passes on its own. The plating bath, the solder and the clasp are where nickel arrives, which is why the report has to name the parts tested.
The Clasp, And Why The Chain Grows
A heavy Cuban chain needs a clasp that matches its weight. The usual answer is a box clasp with a figure-eight safety. A lobster claw on a 100 gram chain is a hinge waiting to open.
The clasp is also where length is lost or gained. A box clasp adds a fixed block to the measured length. A supplier who quotes length without saying so is quoting half a number.
Then there is stretch. Every link has a small amount of play, and a chain worn daily works that play open link by link. A tight build resists it; a loose build with light wire does not.
Two extra grams in the clasp and a tighter fit are cheaper than a repair. A repair on a hollow chain is usually a replacement.
How One Gets Made
Solid Cuban links usually start as wire or as a drawn tube. The tube is cut to length, formed into the link shape, closed, and soldered.
Then each link is filed and polished. That is where the labour sits, and it is why the price of a Cuban chain is not the metal price plus a margin.
Hollow links are made from tube with a thin wall. The tube is drawn to a wall thickness, then cut, formed and joined. That saves metal, but the seam has to be closed without crushing the tube.
Cast links exist as well, and casting suits shape more than it suits a tight Cuban run. A cast link has a grain structure and a sprue mark, and both show under polishing.
The number to ask about is links per piece. A 20 inch chain carries many links, and every one of them is handled at least twice.
What To Measure At Goods-In
Six checks cover most of the risk, and none of them needs a laboratory on site.
Weight per piece against the stated figure, on a scale that reads 0.01 g, with the tolerance written down.
Width at three links, and length with the clasp closed, because that is how the customer measures it.
Clasp pull to an agreed load, held for a set time, then inspected for a gap at the joint.
Plating thickness on the wear face and at a joint, by X-ray, to the figure on the order.
Assay on a sample if the stamp claims a karat, judged against three parts per thousand without solder and seven with it.
Nickel release on any steel or plated piece sold into Europe, to EN 1811, at 0.5 micrograms per square centimetre per week.
Where a shipment is worth more than the inspection, the run is checked before the carton closes rather than after it lands.
Four Blocks In The Price
The quotation is four blocks, and only the first one moves with the market every day.
Metal. Grams times the price of the alloy, which for gold is the spot price scaled by karat and by the alloy’s density.
Labour. Links per piece, times the filing and polishing time per link. This is the block that a hollow build does not reduce, because the handling is the same.
Plating or finishing. Microns of gold, or rhodium over white, plus the rejects from a bath that runs hot.
Findings and packing. Clasp, safety, tag, pouch and box, each with its own minimum.
The lever a buyer actually holds is the build, not the metal. Moving from solid to semi-solid at the same width cuts grams. The labour bill stays almost intact, so the saving is smaller than the weight table suggests.
Six Lines For The Order Sheet
Each line answers a question that a photograph cannot.
One. Width in millimetres, measured at the widest point of a link, with a tolerance.
Two. Length in inches or centimetres, and whether the clasp is inside that figure.
Three. Build: solid, semi-solid or hollow, with the wall thickness if hollow, and the target gram per piece.
Four. Metal and karat, or the base metal and the plating thickness in microns. The fineness and the stamp text belong here too.
Five. Clasp type and the pull load it must survive.
Six. The test list: assay tolerance, plating thickness, nickel release if the market requires it.
All six fit on one page, and one page is what keeps a verbal agreement attached to an order.
For the factory side of the same conversation, the jewellery manufacturer guide covers the rest. The earring guide shows how the same logic works on a smaller part.
Send me a chain quotation or a tech pack. I will check the width and length basis, the build, the target grams and the clasp load. I will also check whether the stamp wording is allowed. No cost, no obligation.
Check My SpecQuestions Buyers Ask
What is a Cuban link chain made of?
Most are gold alloy, and a large volume market is brass or 316L stainless steel with gold plating. The link shape is the same in all three; the metal decides the weight and the price.
Is hollow or solid better?
Solid resists dents and lasts longer, and it costs the full gram. Hollow gives a wider look at under half the metal, and it dents in a way that cannot be repaired. Neither is a defect.
Can a hollow chain be stamped solid gold?
No. Under 16 CFR 23.3 a hollow piece must disclose the hollow centre next to the word Gold, and should not be described as solid. The stamps given in the rule are 14 Karat Gold-Hollow Center and 14 K. Gold Tubing.
How much does an 8 mm Cuban chain weigh?
It depends on length and build. A solid 14 karat chain at 8 mm and 24 inches sits around 110 to 130 grams by retail listings. A hollow build of the same size can weigh less than half.
How thick must gold plating be?
The word plated needs a minimum equivalent to 0.175 microns of fine gold. At 2.5 microns the claim may become heavy gold electroplate. Mechanical plating is measured by weight ratio instead: one fortieth, or one twentieth for gold filled.
Does a stainless steel Cuban chain cause nickel allergy?
316L usually passes, but the limit is on release, not content: 0.5 micrograms per square centimetre per week, tested to EN 1811. Ask for a report that names the parts tested, including the clasp.
Questions & Comments
We read every one and reply within 24 hoursIf a chain quotation or a tech pack crosses your desk, send it over. I will check the width and length basis, the build, the grams and the stamp text.